Dynamic DX Scanner Control TM Basic Operation Instructions
Basic Operation Instructions DX Scanner IMPORTANT NOTICE This manual describes basic operation for the Dynamic DX Scanner Control only and must be read in conjunction with the ownerÂ’s manual supplied with your power chair. Please read both manuals in their entirety before operating the Dynamic DX Scanner Control or your power chair. This manual is intended as a supplement to the in-service training provided by your authorized provider.
DX Scanner Basic Operation Instructions 3 TABLE OF CONTENTS INTRODUCTION ................................................................................ 4 Dynamic DX Scanner Control ................................................................... 4 SELECT MODE ................................................................................... 6 DRIVE MODE ....................................................................................... 6 SEAT MODE ...............................................
Basic Operation Instructions DX Scanner INTRODUCTION Welcome to Quantum Rehab, a division of Pride Mobility Products Corporation (Pride). Quantum Rehab is dedicated to the customization of power chairs for users with advanced rehabilitation and mobility issues. Quantum Rehab also expands possibilities for enhanced healthcare attendant control over power chair functions to provide a secondary level of support for our customers where necessary.
DX Scanner Basic Operation Instructions Module Status LED Drive Mode LED Indicates the status of the Scanner; flashes when there is a fault within the Scanner (not the power chair). Indicates if the Drive Mode is powered on or off. 5 Seating Status LED Seating Mode LED Indicates if actuator control is powered on or off. Indicates if Seating Mode is powered on or off. Environmental Mode LED Indicates if Environmental Mode is powered on or off.
Basic Operation Instructions DX Scanner SELECT MODE 1. Press the On/Off Button on the DX compatible Master Remote used on your power chair. The Module Status LED on the Scanner will light up, indicating that it is in Standby Mode and ready for use. 2. Press the Select Switch once to activate the Scanner. All three Mode LEDs will light up. 3. After power up, the Scanner will begin running through the three modes— Drive, Seat, and Environmental. Each Mode LED will light up in sequence.
DX Scanner Basic Operation Instructions 7 SEAT MODE 1. Press the Select Switch when the Seat Mode LED is lit. Once selected, the Scanner will cycle clockwise around the seating commands (Directional LEDs). 2. There are four Seat Positioning Actuators represented by two each of the Directional LEDs. For example, Actuator 1 is represented by the Forward and the Forward Right Directional LEDs. See figure 3. To extend Actuator 1, wait until the Figure 3.
Basic Operation Instructions DX Scanner ENVIRONMENTAL MODE 1. Press the Select Switch when the Environmental Mode LED is lit. Once selected, the Scanner will cycle clockwise from the top (forward) LED. See figure 2. 2. The first four LEDs are momentary selections, and the last four LEDs are latching selections. Momentary selections will allow the Scanner to continue its cycle immediately after the switch is released.
DX Scanner Basic Operation Instructions NOTES 9
Basic Operation Instructions NOTES DX Scanner
DX Scanner Basic Operation Instructions NOTES 11
Basic Operation Instructions TM Exeter, PA Quantum Hotline: 1-866-800-2002 Visit the Rehab Zone at: www.quantumrehab.
