User`s guide

Quantum ATL M2500 Library User’s Guide Addendum—Prism FC420 Bridge Option
Document 6473031-01, Ver. 1, Rel. 1
August 2002
24 Prism FC420 Services Software Commands
SerialNumber
Reports the FC420 board serial
number.
get serialnumber
SerialPortBaudRate
Set the baud rate for the FC420 serial
port (2400, 9600, 19200, 38400, 57600, or
115200).
9600 set serialportbaudrate [rate]
get serialportbaudrate
SerialPortEcho
Turn on or off the echoing of keyboard
input.
disabled set serialportecho [enabled |
disabled]
SerialPortHandshake
Set the data handshaking method used
for controlling the flow between the
transmitter and receiver (hardware,
software, or none).
none set serialporthandshake [hard
| xon | none]
get serialporthandshake
SerialPortStopBits
Set the number of stop bits for the
FC420 serial port (1 or 2).
1 set serialportstopbits [1 | 2]
get serialportstopbits
ServicesLUN
Identifies the LUNs (one per Fibre
port) to be used during an in-band
command line interface (CLI) session
with a given host. This information is
taken from NVRAM.
Any map coinciding with a user-
specified ServicesLUN must first be set
to offline before attempting to change
the ServicesLUN. This map will be
destroyed upon power-cycling the
Fibre bridge. Disabling a ServicesLUN
for a particular Fibre port will destroy
the map to the Fibre bridge for that
port.
8 set serviceslun [fp] [[fl] |
disabled]
get serviceslun <[fp]>
SpeedWrite
Enables/disables SpeedWrite
functionality to any SCSI device
currently mapped to the Fibre bridge.
To enable/disable SpeedWrite for a
particular device, specify the SCSI bus
(sb), the target (st), and the LUN (sl).
Specify “all” to enable/disable this
option for all currently mapped SCSI
devices.
set speedwrite [sb st sl | all]
[enabled | disabled]
get speedwrite [sb st sl | all]
SpeedWriteDefault
Enables/disables SpeedWrite
functionality as a default condition
when SCSI devices are mapped to the
Fibre bridge.
disabled set speedwritedefault
[enabled | disabled]
get speedwritedefault
Temperature
Reports the unit temperature in
degrees C.
get temperature
Command Description Default Syntax