User Manual and Operating Guide

MAINTENANCE

Storage conditions.

Temperature: -20 to +60°C

Humidity: less than 85% relative humidity.

Do not store the instrument in places where:

1 - There is a high degree of humidity.

2 - The instrument is exposed to direct sunlight.

3 - The instrument is exposed to a source of high temperature.

4 - There are strong vibrations.

5 - There is steam, salt and/or corrosive gas.

The instrument body is made of plastic so it must not be cleaned with sol-

vents which can spoil plastic.

SERIAL OUTPUT

To enable the serial output of the instrument proceed as follows:

1. Insert the SUB D female 9-pole connector of the adapter cable with elec-

tronics AD RS232C in the DIN 9-pole socket on the instrument.

2. Connect the SUB D female 25-pole connector of the fitting to the serial

input of the printer or computer. The position of the switch in the connec-

tor must be:

DCE: data communication equipment (Modem)

DTE: data terminal equipment (Computer)

3. If you want to send what is shown on the display (once only), press the

key until the instrument emits two beeps.

4. If you want to send what is shown on the display continuously, at a fixed

rate of once every 10 seconds, press the

key until the instrument

emits three beeps.

5. To disable the serial output in continuous transmission, press the

key

until the instrument does not emit a beep.

6. If the serial output is not being used it is advisable not to fit the cable

AD RS232C on the instrument, thus saving battery consumption.

7. Serial output: RS232C

Data transmission speed

300 baud

8 data bit length

1 start bit

1 stop bit

no parity

ENGLISH

– 34 –