User`s guide

Chapter 2 Installing the Cartridge Tape Library

Configuring the Tape Library

ATL PowerStor L200 Series Library User’s Guide 23

Configuring the Tape Library

Configuration consists of verifying that the library and the internal

drive have the correct SCSI ID settings.

Figure 18 shows the location of the OCP on the front panel of the

library. Verify SCSI IDs using the OCP. If necessary, change the IDs.

Figure 18 Library Front

Panel

The system uses SCSI IDs to identify or address devices, such as the

loader controller and the tape drive on the SCSI bus.

If the library is one of multiple SCSI devices on the bus, be sure to use

a SCSI ID that is unique from any other device or system ID on the

SCSI bus. Default SCSI IDs are listed in table 2.

Table 2 SCSI ID Default

Settings

Note:

Library power must be recycled for any SCSI ID change to take effect.

Checking the SCSI

Settings

To view the current SCSI ID settings:

SCSI ID Device

1Tape Drive

0 Library Controller

LCD

Select

Enter