User Guide

Step 3 - Setting up device IP address
Click “Configure” and set the device IP address by selecting the required options.
 Connectivity Mode – Ethernet / USB
 Protocol - DHCP, Static or PPPoE
 Interface – Select interface
 VLAN Assignment- Enable parameter. Enter VLAN ID and click “Fetch IP Address” to
get the respective IP in case of VLAN setup is required.
Figure 3
Click “Proceed” to apply configuration and turn to the next page.
Step 4 – Set the management mode
Management Mode
Quantum Networks’ Access Point can be configured in two modes:
RUDDER (on cloud / on-premise)
Centralized management of Access Points using Quantum RUDDER©
Standalone
Independent management of each Access Point