User's Guide

72 SCSI Commands
Import/Export (ImpExp) – A value of one indicates that media present in the element was placed there by
an operator. A value of zero indicates that media present in the element was placed there by a medium
transport element.
Data Transfer Element Descriptor
Element Address – This field contains the element address of the storage element.
Access – This field is set to 1 if access by a medium transport element is allowed. It is set to 0 if access is
denied. When set to 1, it implies that cartridges are unloaded and accessible if present. When set to 0, it
implies that cartridges are not unloaded if present.
Except – This field is set to 1 if the element is in an abnormal state. Additional information may be available
in the Additional Sense Code and Additional Sense Code Qualifier fields. If this field is 1, the primary volume
tag information could be invalid. This field is set to 0 if the element is in a normal state.
Full – This field is set to 0 if the element does not contain media. It is set to 1 if it does.
Additional Sense Code – If the element is in an abnormal state, this field will be set to a value as described
in “Additional Sense Codes and Qualifiers.”
Table 71 Data Transfer Element Descriptor
Bit
Byte
76543210
0
Element Address
1
2 Reserved Access Except Rsvd Full
3 Reserved
4 Additional Sense Code
5 Additional Sense Code Qualifier
6 NotBus Rsvd IDValid LUValid Rsvd Logical Unit Number
7 SCSI Bus Address
8 Reserved
9 SValid Invert Reserved
10
Source Element Address
11
12
:
47
Primary Volume Tag Information
(Field omitted if PVolTag = 0; remaining fields move up)
48 Reserved Code Set
49 Reserved Identifier Type
50 Reserved
51 Identifier Length = x where x is 0h to 40h (valid identifier data)
52
:
115
Device Identifier
(Field omitted if DVCID = 0, remaining fields move up)
(Always padded to 64 byte length if DVCID = 1)