User's Manual

Setting Up Quantum Encryption Key Manager on Your Scalar i500 Library
Document 6-01601-04
March 2010
8
Made in the USA. Quantum Corporation provides this publication “as is” without warranty of any kind, either express or implied, including but not
limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to
time without notice.
COPYRIGHT STATEMENT
© Copyright 2010 by Quantum Corporation. All rights reserved. Your right to copy this document is limited by copyright law. Making copies or
adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law.
TRADEMARK STATEMENT
Quantum, the Quantum logo, and Scalar are registered trademarks of Quantum Corporation. LTO and Ultrium are trademarks of Quantum, IBM, and
HP in the USA and other countries. Other trademarks may be mentioned herein which belong to other companies.
Viewing Tape Drive Encryption Settings 0
You can view the encryption settings in the following ways:
•
System Information Report — To view encryption information on all key servers,
partitions, and tape drives, select
Reports > System Information from the web client.
For more information, see the Scalar i500 User’s Guide.
•
Library Configuration Report — To view the encryption status of a selected tape drive
or tape cartridge, select
Reports > Library Configuration from the web client and click a
tape drive or slot. The encryption status is displayed in a pop-up status window. For
more information, see the Scalar i500 User’s Guide.
•
Partition Encryption — From the web client, select Setup > Encryption > Partition
Configuration
to view and change the encryption status of partitions. See Step 5:
Configure Partition Encryption on page 4 for more details.