Specifications

QT‐AD10Module

9





 PowereitherONorOFF,thisisthetransmitter’spowerstateandcanbechangedhere.
 Frequencycanbeadjustedbymovingthecursortothevalueusingthenavigationalarrows
thenpressing“ENTER”button.Thiswillbringupthescreenshownbelowontheleft.To
changetheMHzvaluesusetheUP/DOWNarrows.Toeditthefrequency’skHz,pressthe
“RIGHT”buttontohighlightthemthenusethe“UP/DOWN”arrowsagain.The“ENTER”or
“BACK”buttoncanbeusedtosavechanges.Select“Save”toconfirmor“Cancel”tocancel.
   
 Batteryisthepercentageofbatteryliferemaining.The“CHG”totheleftofthepercentage
denotesthatthedeviceiscurrentlycharging.
 Micisthemicrophonestate,eitherLiveorMute.Mutingwillturntheaudiooffandleavethe
transmitteron.ThisfunctioncanbeusedtooverrideamutedmicsuchastheQT‐AD10
RefMicwithit’sintegratedmuteswitchortoremotelymuteamicwheneverrequired
 MicGainoffsetisusedtomatchAudioLevelsofdifferenttypesofMicrophones
Whenpairingtwoormoretransmitterstoasinglereceivechannel,theremaybeadifference
involumelevelsbetweenmicrophonesorinstruments.Ifthisoccurs,usetheOffsetfunction
tomatchtheaudiolevelsandeliminateaudiblevolumedifferencesbetweentransmitters.If
usingasingletransmitter,setOffsetto0dB.
SettingGainoffSetifneeded
1. Turnonthefirsttransmitterandperformasoundchecktotesttheaudiolevel.Turn
offthetransmitterwhenfinished.
2. Turnonthesecondtransmitterandperformasoundchecktotesttheaudiolevel.
Repeatforanyadditionaltransmitters.
3. Ifthereisanaudibledifferenceinthesoundlevelbetweenthetransmitters,navigate
totheOffsetmenu(Audio>Offset)inthetransmittertoincreaseordecreasetheOffset
inrealtimetomatchtheaudiolevels.
