User's Manual

18
Low battery Alert
When the battery voltage goes below a preset value, the LED indicator Will flash red and the alert tone
sound and then the radio stops transmitting.
This feature is designed to automatically reminds you of recharging or replace the battery.
Scrambler
T
his feature means that your conversation is secrecy.
If Scrambler is set on the current channel, only the radio setted Scrambler active can receive you, the
radio not setted only get a noise voice.
Compander
Companding is a feature that allows further improvement of voice quality. It compresses your voice at
transmission, and expands it when receiving while simultaneously reducing extraneous noise. However,
to enjoy this benefit, all transmitting and receiving radios must have this feature activated.
Advanced Operations
Monitor
 Squelch Off
In this mode, the speaker is unmuted in any condition so as to receive any sound on the
current channel. When audio signal is received on the channel, audio will be heard.
Otherwise, background noise will be heard.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
 Squelch Off Momentary
Refer to Squelch Off. When audio signal is received on the channel, audio will be heard.
Otherwise, background noise will be heard.
Operation: Hold down the programmed key continuously to enter this mode, and release
the key to exit.
 Monitor
In this mode, the receiving party can receive incoming calls from the transmitting party
regardless of CTCSS/CDCSS condition. If the carrier condition is not satisfied, the
receiving party will fail to receive any incoming calls.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
 Monitor Momentary
Refer to Monitor.
Operation: Hold down the programmed key continuously to enter this mode, and release
the key to exit.
Scan
The Scan feature enables a two-way radio to continuously receive each channel for
activity. Press the programmed Scan key to initiate scanning channels in the order as
they appear in scan list. Status Indicator flashes green during the scan process, and
solidly glows when activity is detected and signaling condition is satisfied on a channel.
Press the key again to exit scanning. When scanning is active, the radio will continuously
scan for activity on scan list members. Once activity is detected on a channel, scanning