User's Manual

Monitor
This feature is enabled/disabled by your dealer.In receive mode,
press the preprogrammed MONI key to monitor activities on the
current channel .This operation is especially useful for adjusting
volume level or receiving a weak signal.The LED indicator glows
green in monitor mode.
Busy Channel Lockout
If the Busy Channel Lockout feature is enabled by your dealer,
it will prevent you from talking on a channel that is already in
use.When you press the [PTT] key , the radio will sound a beep
tone and will not transmit. Release the [PTT] key to stop the
beep tone. Wait until the channel is not in use before you again
try to transmit.
Wired Clone
Cloning enables duplication of radios in the field via a simple
interface cable,without the use of a PC or a special equipment.
PC Programming
Function settings and frequencies can be customized via
programming software.
Selectable Squelch Level(0-9)
The purpose of squelch is to mute audio output from the
speaker when no signals are present.The higher the squelch
level selected,the stronger the signals must be to receive.The
appropriate squelch level depends on ambient RF noise con
ditions.
Priority Channel Scan
Any programmed channel may be set as the priority channel.The
radio will check the priority channel periodically while stopping
on a non-priority channel.When there is any activity on the priority
channel,the radio will automatically switch to the priority channel
for communications.
Programmable 12.5kHz/25kHz Channel Spacing
The feature enables flexibility an easy migration of channel spacing
requirements when the need arises,with no need to buy new radios.
DTMF ANI
This feature is enabled /disabled by your dealer.DEMF ANI is encoded
by PTT ID.Each radio is assigned with one ANI code consisting of
BOT ID (Beginning of Transmission) and EOT ID(End of Transmission).
Each channel can be programmed by PC programming software to
transmit/not transmit ANI code in transmitting mode.
CTCSS/DCS Signalling
CTCSS/DCS may have been programmed on a channel to ignore
unwanted calls from other parties on the same channel.When
CTCSS/DCS signalling is set,user will receive the calls on the same
channel only when the received signals contain the matching
CTCSS/DCS code;otherwise,the user receives all the calls on the
same channel within communication range.
The dealer preset CTCSS/DCS signalling on all or just certain channels.
NOTE:Although using CTCSS/DCS enables you to avoid hearing
Unwanted calls,it does not mean your calls will be private.
VOX
When hands-free operation is desired, your radio can be activated
by voice alone using the VOX feature when you speak through an
accessory that is connected to your radio.
High/low power
High transmit power optimizes range coverage while low transmit
power conserves battery consumption, all at the user's control.