Installation Instructions

CAUTION: Turn off switch at main power source
(fuse box) before installing any Track or fittings.
STEP 1. Place Track over outlet box and mark
position of Track mounting holes on ceiling or wall.
On wallboard or plaster, drill 5/8" mounting holes
and install Track to ceiling or wall using toggle
bolts. On wood surfaces use standard #10 wood screws.
STEP 2. Install lampholders and power fittings.
STEP 3. Switch on main power.
CAUTION: Disconnect power before installation.
To attach lampholder to the Track, align the polarity
lines of the Track and the polarity lines of the lamp-
holder. Push top portion of the adapter (with contact
fingers ) into the slot in the Track and turn 90 if the
adapter does not turn easily, do not force, but turn in
other direction. To remove, depress the release lever
with the index finger and turn 90 .
LAMPHOLDER INSTALLATION
1-2 To mount Track,
drill holes in ceiling or wall.
Attach Track with toggle bolts
or screws if surface is solid material.
1 2
MOUNTING ADAPTER
MOUNTING ADAPTER
TRACK
TRACK
POLARITY LINE
Track
mounting
holes
Plain underside
of Track faces
ceiling or wall
Open,slotted side
of Track faces OUT
to accept lights
Dead end
fitting with
set screw
ASSEMBLY INSTRUCTIONS
CAUTION: