Installation Instructions

3496 5146
FLOATING CANOPY
Junction
box
Ceiling
Junction
box
Black
(hot)
Electrical
adapter
( Figure 2.)
White wire
( Neutral )
Brass terminal
marked "p"
( positive )
Rotate ground
clip to accept
track and push track
into clip
Green ground
wire
Black wire
(Hot)
CAUTION: Turn off switch at main power source ( fuse box )
before installing any track or fittings.
1.Connect the green ground wire to the green ground screw
or the green wire in the junction box. (Figure 1.)
2.After wires are connected, push green wire connected
into junction box and attach mounting bracket to
junction box by two screws. ( Figure 1.)
3.Locate track below junction box in desired position.
then:a) Rotate ground clip to accept track properly
and push track into clip. b) Fasten track to ceiling.
following instructions supplied with the track section.
(Figure 2,)
4.Insert electrical adaptor into track slot and rotate 90
to locked position to make electrical contact
( make sure that two contact fingers turn into the two
slots in the track).NOTE: a) Cenfer line of electrical
adaptor must be set on center line of junction box.
b.) Polarity side on electrical adaptor (The side of
two contact fingers must point to the track polarity
line( Embossed line on the surface of track ) when
correctly installed.(Figure 2.)
5.Pull black wire (positive) from junction box. and
attach to Brass screw terminal marked "P"(positive).
Pull white wire (neutral) on opposite side of track.
and attach to Chrome screw terminal marked "N"
(neutral). (Figure 3.)
6.Push excess wire back into junction box,wire must
hug track side.Install cover and secure with
screw. (Figure 3.)
White ( Neutral )
track
Polarity
line
( 90 )
Mounting
bracket
Mounting
bracket
( Figure 1. )
Ground
clip
Ground clip
NOTE:
If green
ground wire
is available
Nickled plated
terminal
track
Canopy
cover
Tighten
screw
( Figure 3. )