User Manual

1} Motor output short dreuit protection:
Should the motor output short circuit, the controller will eut off the motor outpu! automatical-
!y to proteet lhe controller from damage. Onee the problem has been resolved, you must
re-connect lhe power supply to unlock from protection mode.
(2) Angle overrun protection:
Should lhe camera overrun its maximum angle, the conlroller will cu! the motor output
automatically to pratect the wires from becoming darnaqed.
(1) lhe Q-3D program can be updaled online, any new sóttware will be available via lhe
HobbyKing webpage.
(2) Upgrade tool: use adapter.
(3) Please insert lhe blue single wire into lhe PIT port, insert lhe yellow wire into lhe ROLL
port, insert lhe black wire imo lhe GND port.
tr.JD ;;;
Ç"g ;~Ô
•••
Venow wire(ROLL)
., :>..-. BI~e wlre(PIT) USB
~~_~":d_'
USB
-8-
DisconnecU
Red LED flashes quickly
Electricity in lhe initialization,
connec! with
please keep lhe gimbal steady
receiver
Green LED keeps sotid Initialization finished
Red LED keeps solid Receiver tilt channet be connected.
Connect with receiver
Blue LED keeps solid
Receiver rolling channel can be conne
EnterPAM
Red/bluelyellow LED flashes
Enter PAM settings
quic/dy 1 simullaneously
Red LED flashes
Enter tilt motor output power and gain
quicklylslowly control adjustmenl
nl! Molor OUIPU!
Blue LED lighl 0111
Power and Gain
P~contral knob is not centered
ContraI Adjusting
keeps solidl flash
Yellow LED light 0111
ROLL contrai knob is nol centered
keeps solidl flash
Blue LED flashes
Enter rall motor output power and
quicklyl slowly
gain contrai adjustrnent
RolI Motor Output
Red LED light 0111
Power and Gain
PIT contrai knob is not centered
Control Adjusting
keeps solidl flash
Yellow LED lighl offl
I ROLL conlrol knob is nol cenlered
keeps solidl flash
j Yellow LED flashes
I Enter horizontal motor output power
Horizontal Motor
; quickly/ slowly
and gain contrai adjustment
Output Power
i
I PIT control knob is not cen!ered
I Red LED light oiíl
and Gain Conlrol
keeps solidf flash
ft.djusting
Blue LED Hghtoií/
I ROLL contrai knob is no! centered
keeps solid f flash
Parameters saving
Green LED l<eepssolid
I Save paramelers and Exit PAM setlint
and exit PAM Settings
-9-