Getting Started Guide
74
Advanced Operation
the transmitter will release the hold and allow the PTT to transmit. e repeating hold
timer sets the hold time for the transmitter to resume transmitting 100ms-5000ms (5
seconds) after the received QT/QDT signal disappears. is function is only accessible
and congured through the KG-1000G programming software.
Setting Non-Standard CTCSS or DCS
How to Set Non-Standard CTCSS
e KG-1000G supports non-standard CTCSS codes in the range of 65.0-255.0Hz
with a minimum spacing of 0.1Hz.
Note
When the radios are in repeater mode, both primary and second-
ary areas of the radios are the receiver. e area that receives the
signal rst will be the receiver, and the other area will act as the
transmitter.