Installation manual

CCM-3211 Series Installation Manual
9
Adjusting and Framing Up the Camera View
4.3 Power and Ethernet Cable Connection
Power Connection
Make sure the camera’s power cable is properly connected. Refer to the pin definition table in
Camera Connectors. If using Power over Ethernet (PoE), make sure Power Sourcing
Equipment (PSE) is available on the connected network. All electrical work must be
performed in accordance with local regulatory requirements.
Ethernet Cable Connection
Use of Category 5 Ethernet cable is recommended for network connection. For best
transmission quality, cable length should not exceed 100 meters (328 feet). Connect one
end of the Ethernet cable to the RJ-45 connector of the CM-3211-xx camera and the other
end to the network switch or PC.
NOTE: You can use an Ethernet crossover cable to connect the CM-3211-xx directly
to a PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are unlit, check
the LAN connection.
The green Link LED indicates a good network connection.
The orange Activity LED flashes to indicate network activity.
AUTO
IRIS
1 2 3 4
I/O
NETWORK
DC12V
LINE
LINE IN
MIC IN
OUT
VIDEO
DC
RESET