Installation manual

CCM-3211 Series Installation Manual
17
5.) Plug the CAT5 cable into the camera’s Ethernet port and, if needed, plug the
power terminal block into the power terminals.
6.) If applicable, wire the Alarm In, Alarm Out, Audio In, and Audio Out terminal
blocks to external devices.
HD Series Connections
7.) If needed, connect the other end of the CAT5 cable to the network and turn on the
power from the power supply.
Note: Do not reassemble the camera’s inner cover and dome cover until after
hardware configurations and lens adjustments are made.
30v24211
j1Dr1.0