Installation manual

CCM-3211 Series Installation Manual

6.) Do the one of the following.

For DHCP (not supported by Latitude):

a.) Select “DHCP”. Do not use for Latitude.

b.) Click “Apply”. When prompted with instructions to search again after one

minute, click “OK”.

c.) After one minute, click “Device Search”.

For Static IP (recommended for Latitude users):

a.) Select “Static IP” (preferable for security and Latitude users). In the IP

Address, Gateway, and Netmask, enter the respective values for your

LAN/VLAN (optional DNS).

b.) Click “Apply”. When prompted with instructions to search again after one

minute, click “OK”.

c.) After one minute, click “Device Search”. The communication settings should

now be changed and ready for you to install the CM-3221-xx camera on the

network. You may access it either via the browser-based viewer or Latitude

NVMS.

7.) Right-click and select “Browse” to directly access the camera via a web browser.

The default web browser opens and requests access to the camera IP address.