Installation manual

CCM-3211 Series Installation Manual
47
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4)
are allowed/denied access to the camera.
Select “Allow” or “Deny” from the drop-down list and click the “Apply” button to determine
the IP Filter behavior.
Add/Delete IP Address
Input the IP address and click the “Add” button to add a new filtered address. The Filtered IP
Addresses box shows the currently configured IP addresses. Up to 256 IP address entries
may be specified. To remove an IP address from the list, select the IP address and then click
the “Delete” button.
6.3.2.4 IEEE 802.1X
The camera is allowed to access a network protected by 802.1X/EAPOL (Extensible
Authentication Protocol over LAN). Users must contact the network administrator to obtain
certificates, user IDs, and passwords.