Installation manual

CCM-3211 Series Installation Manual

 Subnet mask

The subnet mask is used to determine if the destination is in the same subnet.

The default value is “255.255.255.0”.

 Default gateway

The default gateway is the gateway used to forward frames to destinations in a

different subnet. An invalid gateway setting causes transmission to destinations

in other subnets to fail.

 Primary DNS

The primary DNS is the primary domain name server that translates hostnames

into IP addresses.

 Secondary DNS

The secondary DNS is a secondary domain name server that backs up the

primary DNS.

 Use PPPoE

PPPoE users should enter their PPPoE Username and Password into the respective

fields. Click on the “Save” button to save the settings.

Advanced

 Web server port

The default web server port is 80. Once the port is changed, the user must be

notified the change for the connection to be successful. For instance, when the

Administrator changes the HTTP port of the camera whose IP address is

192.168.0.100 from 80 to 8080, the user must type in the web browser

“http://192.168.0.100:8080” instead of “http://192.168.0.100”.

 RTSP port

The default setting of the RTSP Port is 554. The range is between 1024 to 65535.

 MJPEG over HTTP port

The default setting of MJPEG over HTTP Port is 8008. The range is between 1024

to 65535. Note that MJPEG is not supported by Latitude.

 HTTPS port

The default setting of HTTPS Port is 443. The range is between 1024 to 65535.

NOTE: Be sure to assign a different port number for each separate service

mentioned above.

 MTU

The default MTU (Maximum Transmission Unit) is the greatest amount of data

that can be transferred in one physical frame on the network. For Ethernet, the

MTU is 1500 bytes. For PPPoE, the MTU is 1492.

Click “Save” to save the settings.

IPv6 Address Configuration

With IPv6 support, users can use the corresponding IPv6 address for browsing. Enable IPv6

by checking the box. Click “Save” to save the setting.