Installation manual

CCM-3211 Series Installation Manual

 Upload Image by FTP

Select this box to assign an FTP site and configure the parameters shown in the

figure below. When an alarm is triggered, event images are uploaded to the

designated FTP site.

Specify which one of two FTP addresses you wish to use from the drop-down

menu. Select the number of frames for the pre-trigger and post-trigger buffers

from the drop-down menu of 1-20 frames.

Check the box for “Continue image upload” if you wish to use this option. If

you wish to specify the length of time for the upload, click on this radial button

and enter the number of seconds. If you wish to upload during the active trigger,

click on this radial button. Finally, select the number of frames per second from

the drop-down menu next to “Image frequency”.