Installation manual

CCM-3211 Series Installation Manual
67
 Upload Image by E-Mail
Select this box in order to assign an e-mail address and configure various
parameters as shown in the figure below. When the alarm is triggered, event
images are sent to one of two designated e-mail addresses. Select the number of
frames for the pre-trigger and post-trigger buffers from the drop-down menu of
1-20 frames.
Check the box for “Continue image upload” if you wish to use this option. If
you wish to specify the length of time for the upload, click on this radial button
and enter the number of seconds. If you wish to upload during the active trigger,
click on this radial button. Finally, select the number of frames per second from
the drop-down menu next to “Image frequency”.
NOTE: Make sure that SMTP or FTP configuration has been completed. See Mail and
FTP for further details.