Installation manual

CCM-3211 Series Installation Manual

Triggered Action

The Administrator can specify alarm actions to be taken when motion is detected. The

options are listed as follows:

 Enable Alarm Output

Check this box to select the predefined type of alarm output in order to enable

alarm relay output when motion is detected. Select either “Low” or “High” relay

output.

 Record Stream to SD Card

Select this box to store the motion detection recording in a Micro SD/SDHC card

when motion is detected.

NOTE: Make sure that local recording (with a Micro SD/SDHC card) is activated so

that this function can be implemented. See Recording for further details.

 Send Alarm Message by FTP/E-Mail

Select whether to send an alarm message by FTP and/or e-mail when motion is

detected.

 Upload Image by FTP

Select this box in order to upload an image by FTP and to configure various

parameters as shown in the figure below. When motion is detected, event images

are uploaded to the designated FTP site.

Specify which FTP address you wish to use from the drop-down menu. Select the

number of frames for the pre-trigger and post-trigger buffers from the drop-down

menu of 1-20 frames.

Check the box for “Continue image upload” if you wish to use this option. If

you wish to specify the length of time for the upload, click on this radial button

and enter the number of seconds. If you wish to upload during the active trigger,

click on this radial button. Finally, select the number of frames per second from

the drop-down menu next to “Image frequency”.

 Upload Image by E-Mail

Select this box in order to assign an e-mail address and configure various

parameters as shown in the figure below. When motion is detected, event images

are sent to one of two designated e-mail addresses. Select the number of frames

for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20

frames.