Installation manual

CCM-3211 Series Installation Manual

 Enable Alarm Output

Select this box to enable alarm relay output. Select either “Low” or “High” relay

output.

 Record Stream to SD Card

Select this box in order to save the alarm-triggered recording into your Micro SD

card. Enter the number of seconds for the pre-trigger buffer. Select the first

radial button if you wish to upload for a specified length of time and enter the

number of seconds. Alternatively, select the second radial button to upload during

the active trigger.

NOTE: Make sure that local recording (with a Micro SD/SDHC card) is activated so

that this function can be implemented. See Recording for further details.

 Send Message by FTP/E-Mail

Select whether to send an alarm message by FTP and/or e-mail when a network

failure is detected.