Installation manual

CCM-3211 Series Installation Manual

Tampering Duration

The tampering duration is the time for video analysis to determine whether camera

tampering has occurred. Minimum duration defines the tampering threshold. A longer

duration represents a higher threshold. The minimum duration time ranges from 10 to 3600

seconds.

Triggered Action

Specify the alarm actions to be taken when tampering is detected. The options are as

follows:

 Enable Alarm Output

Check this box and select the predefined type of alarm output (“high” or “low”)

to enable alarm relay when tampering is detected.

 Record stream to SD Card

Select this box to store the Tampering Alarm recording in a Micro SD/SDHC card

when tampering is detected.

NOTE: make sure the local recording (with Micro SD/SDHC card) is activated so that

this function can be implemented. See Recording for further details.

 Send Alarm Message by FTP/E-Mail

Select whether to send an alarm message by FTP and/or e-mail when tampering

is detected.

 Upload Image by FTP

Select this box in order to upload an image by FTP and to configure various

parameters as shown in the figure below. When motion is detected, event images

are uploaded to the designated FTP site.

Specify which FTP address you wish to use from the drop-down menu. Select the

number of frames for the pre-trigger and post-trigger buffers from the drop-down

menu between 1-20 frames.

Check the box for “Continue image upload” if you wish to use this option. If

you wish to specify the length of time for the upload, click on this radial button

and enter the number of seconds. If you wish to upload during the active trigger,

click on this radial button. Finally, select the number of frames per second from

the drop-down menu next to “Image frequency”.