Installation manual

CCM-3211 Series Installation Manual

 Upload Image by E-Mail

Select this box in order to assign an e-mail address and configure various

parameters as shown in the figure below. When motion is detected, event

images are sent to one of two designated e-mail address.

Specify which of two e-mail addresses you wish to use from the drop-down

menu. Select the number of frames for the pre-trigger and post-trigger buffers

from the drop-down menu between 1-20 frames.

Check the box for “Continue image upload” if you wish to use this option. If

you wish to specify the length of time for the upload, click on this radial button

and enter the number of seconds. If you wish to upload during the active trigger,

click on this radial button. Finally, select the number of frames per second from

the drop-down menu next to “Image frequency”.

NOTE: Make sure SMTP or FTP configuration has been completed. See Mail and FTP

for further details.

 Send HTTP notification

Check this box to select the destination HTTP address and specify the parameters

for HTTP notifications. When the Tampering Alarm is triggered, the HTTP

notifications are sent to one of two specified HTTP servers.

File Name

The uploaded image’s filename format is set in this section. Select one that meets your

requirements.

Save

Click the “Save” button to save the Tampering Alarm settings.

6.3.12 Storage Management

Users can implement local recording of up to 32GB on a Micro SD/SDHC card. The Storage

Management page shows the capacity information of the Micro SD card and a recording list