Installation manual

CM-4221 Installation Manual
15
7.) If needed, connect the other end of the CAT5 cable to the network and turn on the
power from the power supply.
Note: Do not reassemble the camera’s inner cover and mini-dome cover until after
hardware configurations and lens adjustments are made.
4.6.2 Mounting the CM-4221-01, CM-4221-11, or CM-4221-
11-I Outdoor Camera
1.) Do one of the following:
 For drilled wall or ceiling mounting:
a.) Use a pointed pencil and the base as a template to mark the mounting surface
through the plate holes where the four screw holes need to be drilled.
Important: Before marking and drilling the holes, ensure that the base plate
alignment is oriented correctly so that the required camera field of view can be
achieved when the system is assembled.
b.) In the marked locations, drill each hole using a drill-bit of a slightly smaller
diameter than the supplied screw anchors (molly-plug anchor). You want to
achieve a snug insertion so that the plug expansion holds firm after the screws
are screwed in.
c.) Fully insert the supplied anchors into drilled holes. You may need to tap them
flush with the wall using a finishing hammer.
 For installing on a 4S recessed electrical box:
a.) Have a qualified installer (check your local electrical codes) rough-in the 4S
recessed electrical box and run the wires and power (if not PoE) through the
wall/conduits to the box location.