Installation manual

CM-4221 Installation Manual
22
Tip: Record the camera’s MAC address for future identification.
6.) Do the one of the following.
For DHCP (not supported by Latitude):
a.) Select “DHCP”. Do not use for Latitude.
b.) Click “Apply”. When prompted with instructions to search again after one
minute, click “OK”.
c.) After one minute, click “Device Search”.
For Static IP (recommended for Latitude users):
a.) Select “Static IP” (preferable for security and Latitude users). In the IP
Address, Gateway, and Netmask, enter the respective values for your
LAN/VLAN (optional DNS).
b.) Click “Apply”. When prompted with instructions to search again after one
minute, click “OK”.
c.) After one minute, click “Device Search”. The communication settings should
now be changed and ready for you to install the CM-3221-xx camera on the
network. You may access it either via the browser-based viewer or Latitude
NVMS.