Installation manual

CM-4221 Installation Manual
48
6.3.2.3 IP Filter
The IP filter restricts access to the camera by denying/allowing specific IP addresses.
General
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4)
are allowed/denied access to the camera.
Select “Allow” or “Deny” from the drop-down list and click the “Apply” button to determine
the IP Filter behavior.
Add/Delete IP Address
Input the IP address and click the “Add” button to add a new filtered address. The Filtered IP
Addresses box shows the currently configured IP addresses. Up to 256 IP address entries