Installation manual

CM-4221 Installation Manual
75
When motion is detected, the signals are displayed in the Motion window as shown below.
Detailed settings for Motion Detection are as follows:
Motion Detection
Activate this function by selecting “On” or “Off”. Default setting is “Off”.
Motion Detection Setting
Various parameters of Motion Detection can be set in this section.
 Sampling pixel interval [1-100]:
The default value is 10, which means the system will take one sampling pixel for
every 10 pixels.
 Detection level [1-100]:
The default level is 10. The item is to set detection level for each sampling pixel;
the smaller the value, the more sensitive it is.
 Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are detected
differently, the system will detect motion. The bigger the value, the more
sensitive it is. When the value is bigger, the red horizontal line in the motion
indication window will be lowered accordingly.
 Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each detected
motion.
Triggered Action
The Administrator can specify alarm actions to be taken when motion is detected. The
options are listed as follows: