Network USB2.0 Device Server Over IP 4-Port USB2.0 Device User Manual

After Selecting IP Configuration key in the IP Address of the USB device server in the IP Address
field followed by proper Subnet Mask & Gate Way as shown below.
After entering IP address, Subnet Mask & Gate Way then click on “save” button. Then USBIP
Admin shows progress bar for some time and after it pops up a message box as shown below.
Note: Every board in the network is identified by its IP address. The utility treats each IP address
as unique device. Even if the IP address of the box is modified it treats the same box as a different
device and will pop up a Found New Hardware Wizard.
Continue the Found New Hardware Wizard to install the Virtual USB-over-IP bus driver.
Now the USB device server appears with changed IP Address under USBIP Admin utility.
Password:
The Password Settings page allows you to change or Enable/Disable password of the USB device
server. The Password settings page will be as shown below.