Specifications

2 – CLI Commands
Page 20 Airborne™ Product Family CLI Reference Guide 100-8005-101G
Quatech, Inc. Confidential
2.2 CLI COMMANDS
Note:
Some CLI commands require the Module to be restarted before they take
effect, while others do not. In the following sections, an asterisk (*) in the Ln
column denotes a command that requires the Module to be restarted. Use
the CLI command commit to store your current changes to flash memory
before restarting; otherwise, changes will be discarded at the next restart.
The following tables list each CLI command with their corresponding arguments, access level,
and description:
2.2.1 LAN Configuration Commands
Command CLI Arguments Ln Description
wl-ip [IPadrs] L3* Configures the static IP address of the Module if the DHCP Client is
disabled.
Default is 0.0.0.0.
wl-subnet [IPadrs] L3* Configures the static Subnet Mask of the Module if the DHCP Client
is disabled.
Default is 255.255.255.0.
wl-gateway [IPadrs] L3* Configures the static gateway IP address of the Module if the DHCP
Client is disabled.
Default is 0.0.0.0.
wl-udap [<0 | 1>] L3* Configures the UDAP Discovery feature to enable or disable. UDAP
Discovery is required for discovery of the Module in the subnet by
applications like the AEU and the OCT.
0 = disable
1 = enable (default)
wl-dhcp [<0 | 1>] L3* Configures the DHCP Client to enable or disable. If the DHCP client
is enabled, the Module will use DHCP to obtain an IP configuration. If
DHCP fails to obtain the IP configuration, the Module’s IP address
will be 0.0.0.0. However, if wl-dhcp-fb is enabled, then the
values from wl-dhcp-fbip, wl-dhcp-fbsubnet, wl-dhcp-
gateway will be used as the static IP address, subnet mask and
gateway address until the Module is power cycled.
0 = disable
1 = enable (default)
wl-ip-source L3 Method by which current IP address was obtained. This command is
read only.
n = IP address invalid
d = DHCP
s = static
f = fallback
wl-dhcp-rel L3 Releases the current DHCP lease so that wl-dhcp-renew can get a
new one.