User`s manual

2.2 Changing Configuration of the QSP-200/300.
To change the hardware configuration of the QSP-200/300, follow the instructions
below.
2.2.1 Windows 95/98/ME
1. Double click the My Computer icon located on the Windows 95/98/ME
desktop.
2. Double click on the Control Panel icon.
3. Double click the System icon inside the Control Panel folder. This will
open the System Properties box.
4. Click the Device Manager tab located along the top of the System
Properties box.
5. Double click on the device group "Quatech Comm Adapters". The
QSP-200/300 model name should appear in this list. If either the "Quatech
Comm Adapters" group or the QSP-200/300 model number does not
appear, contact Quatech Technical Support for further assistance.
6. Click on the QSP-200/300 item and then click on the button labeled
"Properties".
7. Un-check the box "use automatic settings". This keeps Windows from
changing the resource settings when the system is restarted.
8. Select a "Basic Configuration" from the list box. Each "Basic Configuration" is
associated with a specific set of handshake and output driver options as
listed in the table below (a functional description of these options are
contained in the section Hardware Information).
9. If a change in I/O address and / or IRQ setting is required, select the
resource to be modified (I/O or IRQ) and select "Change Settings". Make
the desired changes and then click on "OK". A shutdown of the system may
be required to allow the settings to change. If prompted for a shutdown,
select the option which restarts Windows 95.
10. The QSP-200/300 will be automatically reconfigured to the desired settings.
11. The card is now ready for use.
2.2.2 Windows 2000
1. Double click the My Computer icon located on the Windows 2000 desktop.
2. Double click on the Control Panel icon.
QSP-200/300 User's Manual 11