Specifications

4.19 Replacing the DC Switch
The following steps describe the removal procedure for the DC power switch.
Refer to Figure 4–30 and Table 4–32 during the procedure.
1. Shut down the system and unplug the power cord (Section 4.4).
2. Remove the top cover, side panels, and lower front bezel using the
procedure in Section 4.5.
3. Pull off the two push-on terminals from the back of the DC switch. These
push-on terminals are part of the DC switch wire assembly.
4. Push the plastic spring ears on each side of the switch and lift the switch
out of the front of the chassis.
Reverse the above procedure to install the DC switch.
4–58 FRU Removal and Replacement