GV50MG User Manual GB100CAU User Manual EGPRS /GPRS/WCDMA/LTE Cat 1/GNSS Tracker QSZTRACGB100CAUUM0100 Version: 1.
GB100CAU User Manual Document Title GB100CAU User Manual Version 1.00 Date 2020-06-12 Status Released Document Control ID QSZTRACGB100CAUUM0100 General Notes Queclink offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Queclink. The information provided is based upon requirements specifically provided to Queclink by the customers.
GB100CAU User Manual Contents 0. Revision History ............................................................................................................................. 1 1. Introduction .................................................................................................................................. 2 1.1. GB100CAU Products ............................................................................................................ 2 1.2. Reference....................................
GB100CAU User Manual 0. Revision History Version Date Author Description of Change 1.
GB100CAU User Manual 1. Introduction The GB100CAU is a device designed for self-installation by the customer. It is a telematics device based on LTE CAT1/WCDMA/EGPRS supporting Bluetooth. Its built-in accelerometer allows motion detection, incident detection, 100/200/400Hz pre/post incident data collection and extends battery life through sophisticated power management algorithms. System integration is straightforward as complete documentation is provided for the full featured @Track protocol.
GB100CAU User Manual 2. Product Overview 2.1. Product Appearance Figure 1. Appearance of GB100CAU 2.2. LED Description Table 3.
GB100CAU User Manual 3. Interface Definition The GB100CAU has a 2-pin power cable. The pin definition of the 2-pin power cable is as below: Table 4.
GB100CAU User Manual 4. Getting Started 4.1. Opening the Case Insert the triangular-pry-opener into the gap of the case as shown below, push the opener up until the case unsnapped. Figure 2. Opening the Case 4.2. Closing the Case Make sure the silicon rubber seal ring is in the gap of front case. Put the power cable wire holder in the rubber groove of rear case. Place the cover on the bottom in the position as shown in the following figure.
GB100CAU User Manual 4.3. Installing SIM Card Open the case and ensure the unit is not powered. Slide the holder to right direction to open the SIM card slot. Insert the SIM card into the holder as shown below. Close the SIM card holder and then close the case. 4.4. Power Connection PWR (pin 1)/GND (pin2) are the power input pins. The input voltage range for this device is from 8V to 32V. The device is designed to be installed in vehicles that operate on 12V/24V without the need of external transformers.
GB100CAU User Manual 5. Installation Precautions Firmly install the device to a reliable surface to prevent falling off. Make the side with antenna face sky to have better signal reception. Do not install the device under metal surface or in enclosed environments having difficulty in getting GPS and network signal.
GB100CAU User Manual 6. Troubleshooting and Safety Info 6.1. Troubleshooting Problem After the device is turned on, the CEL LED always flashes quickly. Possible Reason The signal is too weak. The device isn’t registered to the network. APN is not right. Messages can’t be reported to the backend server by The IP address or port of the network. backend server is wrong. There is no response from the device when the device is configured by using Manage Tool. The device can’t get GPS fix.
FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.
