User's Manual

M10 Hardware Design
M10_HD_V3.0 - 9 -
1. Introduction
This document defines the M10 module and describes the hardware interface of M10 module
which are connected with the customer application and the air interface.
This document can help customer quickly understand module interface specifications, electrical
and mechanical details. Associated with application notes and user guide, customer can use M10
module to design and set up mobile applications easily.
1.1. Related documents
Table 1: Related documents
SN Document name Remark
[ 1] M10_ATC AT comm a n d s s e t
[2] ITU-T Draft new
recommendation V.25ter
Serial asynchronous automatic dialing and control
[3] GSM 07.07 Digital cellular telecommunications (Phase 2+); AT
command set for GSM Mobile Equipment (ME)
[4] GSM 07.10 Support GSM 07.10 multiplexing protocol
[5] GSM 07.05 Digital cellular telecommunications (Phase 2+); Use of
Data Terminal Equipment – Data Circuit terminating
Equipment (DTE – DCE) interface for Short Message
Service (SMS) and Cell Broadcast Service (CBS)
[6] GSM 11.14 Digital cellular telecommunications (Phase 2+);
Specification of the SIM Application Toolkit for the
Subscriber Identity module – Mobile Equipment (SIM –
ME) interface
[7] GSM 11.11 Digital cellular telecommunications (Phase 2+);
Specification of the Subscriber Identity module – Mobile
Equipment (SIM – ME) interface
[8] GSM 03.38 Digital cellular telecommunications (Phase 2+);
Alphabets and language-specific information
[9] GSM 11.10 Digital cellular telecommunications (Phase 2); Mobile
Station (MS) conformance specification; Part 1:
Conformance specification
[10] GSM_UART_AN UART port application notes
[11] M10_HD_AN01 M10 hardware design application notes
[12] GSM_FW_Upgrade_AN01 GSM Firmware upgrade application note
[13] M10_EVB_UGD M10 EVB user guide application notes