User's Manual

M80 Hardware Design
M80_HD_V1.2 - 32 -
illustrated in Figure 4. The capacitors should be placed close to the M80 VBAT pins.
The PCB traces from the VBAT pads to the power source must be wide enough to ensure that
there isn’t too much voltage drop occurring in the transmitting burst mode. The width of trace
should be no less than 2mm and the principle of the VBAT trace is the longer, the wider. The
VBAT voltage can be measured by oscilloscope.
C2C1
VBAT
+
C1=100uF, C2=0.1uF~1uF
Figure 4: Reference circuit of the VBAT input
3.3.3. Reference power design for module
The power design for the module is very important and the circuit design of the power supply for
the module largely depends on the power source. Figure 5 shows a reference design of +5V input
power source. The part number of this LDO IC is MIC29302WU. The designed output for the
power supply is 4.16V and the maximum load current is 3A, in order to prevent from outputting
abnormal voltage, a zener voltage regulator is employed at the point of the output nearby the pin
of VBAT. Some elements have to be taken into account during the component selection, such as
reverse zener voltage is recommend 5.1V and the total dissipation is more than 1Watt.
C1
100uF
C2
MIC29032 U1
IN OUT
EN
GND
ADJ
2 4
1 3 5
DC_IN VBAT
100nF
C3
100uF
C4
100nF
C5 C6
33pF
R1
10pF
D1
120K
51K
R2
Figure 5: Reference circuit of the source power supply input