Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Citrix SD-WAN Quick Start Guide: 110 LTE WiFi Standard Edition (SE) 1
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Copyright and Trademark Notice Copyright © 2018 Citrix Systems, Inc. All rights reserved. NO PART OF THIS DOCUMENT MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM OR BY ANY MEANS OR USED TO MAKE DERIVATIVE WORK (SUCH AS TRANSLATION, TRANSFORMATION, OR ADAPTATION) WITHOUT THE EXPRESS WRITTEN PERMISSION OF CITRIX SYSTEMS, INC.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Contents Contents ........................................................................................................................................................ 3 Quick installation and configuration ............................................................................................................. 4 Before you begin ............................................................................................................................
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Quick installation and configuration Review the following information before proceeding with installation of the SDWAN 110-LTE-WiFi-SE appliance. Before you begin Verify that the following components and accessories are included: Citrix SD-WAN 110-LTE-WiFi-SE appliance. Accessory contents: • • • • Power adapter - 1 Power cable - 1 Rubber feet ( Desktop mount) – 4 Wall mount screws - 2 Optionally, you can also purchase the rack mount shelf.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Citrix SD-WAN 110-LTE-WiFi-SE The Citrix SD-WAN 110-LTE-WiFi-SE platform is a branch side appliance that can be deployed in micro and small branch offices/Remote sites/ retail stores, and temporary worksites. It is a single box in branch solution that helps to reduce hardware foot print and eases branch deployment. The Citrix SD-WAN 110-LTE-WiFi-SE appliance is a desktop form factor appliance.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide LTE SIM Card Slot LTE OFF: No signal 1 bar: Poor 2 bar: Fair 3 bar: Good 4 bar: Excellent Mini (2FF) size SIM. Adapters provided in the accessory kit can be used to enable use of Micro (3FF) and Nano (4FF) size SIMs. Snap the smaller SIM into the adapter. LTE antenna male connector.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Figure 2. Citrix SD-WAN 110-LTE-WiFi-SE back panel Note: Port 1/1 is the default LAN port and port 1/2 is the default WAN port. Port 1/3 is disabled. The default LAN IP is 192.168.0.1. For LTE appliances, the LTE SIM slot is also the default WAN port. The WAN ports are configured as DHCP clients. Port Label LTE Type Description Connector for LTE antenna.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide 8
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Appliance physical installation procedure and precautions • Horizontal or vertical mount • • Install the equipment near an electrical outlet for easy access. Place equipment in a rack with sufficient airflow for safe operation. • For a closed or multiple-unit rack assembly, the ambient operating temperature of the rack environment might be greater than the ambient temperature of the room.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Ensure that the power supply cords include grounding plugs and are plugged into grounded electrical outlets. Ensure that the power source can handle the appliance's maximum power consumption rating with no danger of an overload. A reliable ground must be maintained at all times. Therefore, the rack should be grounded.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide • • Screw head: ∅6.0mm ~ ∅7.5mm Screw body: 3.5mm Rack mount the appliance 1. Fix the shelf to the rack with the provided screws. 2. Install the chassis. Place the appliance screw slots on the positioning screws on the shelf and slide it, to lock it into position. 3. Install the chassis fix bracket to hold the appliance in position. Place the chassis fix bracket on the slot and fix it with a screw.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide 4. Install the power adapter. Place the power adapter on the adapter slot. 5. Install the adapter fix bracket to hold the power adapter in position. Place the adapter fix bracket on the slot and fix it with a screw.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Installing the LTE antennas To use the Citrix SD-WAN 110-LTE-WiFi-SE appliance as an LTE modem, install the antennas to the appliance. The antennas are included in the appliance package. The Citrix SD-WAN 110-LTE-WiFi-SE appliance has two SMA coax male connectors at the front and rear of the appliances. The antennas have independent rotating SMA female connectors. Note: Ensure that both the LTE antennas are installed for better LTE cellular connectivity.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide 3. Similarly connect the other antenna to the rear SMA coax connector (M) of the appliance. For more information on configuring the LTE functionality using the GUI and CLI, see Configure LTE functionality. 已註解 [PK[4]: Connecting the appliance to a power source 已註解 [PK[5R4]: I think the content in the topic, need to be made generic. Applicable to all LTE appliances. Please confirm.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide To set up your Citrix SD-WAN appliance hardware, do the following: 1. Set up the chassis. For desktop installation, place the chassis on a flat surface. Ensure that there is a minimum of two inches of clearance at the sides and back of the appliance for proper ventilation. 2. Connect the Power. a. Ensure that the power switch is set to off. b. Plug the power cord into the appliance and an AC outlet. c.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide You need to change the Ethernet port settings on the PC before you can set the appliance management IP address. Record the original settings so you can restore them after configuring the management IP address. 3. Change the IP address for the PC. On the PC, open your network interface settings and change the IP address for your PC to the following: • 192.168.100.50 4. Change the Subnet Mask setting on your PC to the following: • 255.255.0.0 5.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide System specifications The following table summarizes hardware specifications for the Citrix SD-WAN 110-LTEWiFi-SE platform edition. Specifications Regulatory model number Memory Non-Volatile Storage LTE WiFi LAN Ports USB 2.0 SIM Slot LTE Antenna Power Supplies External power supply ratings 110-LTE-WiFi-SE SD-WAN 110-LTE-WiFi Appliance Ratings Input voltage 4GB 32GB 3G, 4G Dual band 2.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Wireless WAN (LTE) Specifications LTE capabilities Module Geography LTE category Carrier aggregation SIM xlots LTE bands Tx output power Antennas 110-LTE WiFi Quectel EG25-G Global Cat-4 No 2 (only 1 active) B1/B2/B3/B4/B5/B7/B8/B12/B13/B20/B25/B26/B28/B38/B39/B40/B41 Class 3 (23dBm±2dB) Frequency 690-960 Peak Gain 1.18 dBi 150Mbps downlink/50Mbps uplink Theoretical speeds 1710-2220 4.5 dBi 2500-2700 4.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Compliance Responsible Party – U.S. Contact Information: Citrix Systems, Inc. 4988 Great America Parkway Santa Clara, CA 95054 USA compliance.prime@citrix.com This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Netherlands (NL), Norway (NO), Poland (PL), Portugal (PT), Romania (RO), Slovakia (SK), Slovenia (SI), Spain (ES), Sweden (SE), Switzerland (CH), Turkey (TR), United Kingdom (UK). This radio transmitter model has been approved to operate with the antennas provided with the device. Any other antennas are strictly prohibited for use with this device.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 20cm between the radiator and your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé.
Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide Additional information For information about other Citrix SD-WAN platform editions, see Citrix SD-WAN Platforms. To contact Citrix Support, call 1-800-4-CITRIX (1-800-424-8749), or log on to My Citrix at http://www.citrix.com. You will be asked for your hardware serial number as part of the support process. Detailed instructions for contacting support can be found at: https://www.citrix.com/contact/technical-support.html.
