Quick Start Guide

Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide

3. Similarly connect the other antenna to the rear SMA coax connector (M) of the

appliance.

For more information on configuring the LTE functionality using the GUI and CLI, see

Configure LTE functionality.

Connecting the appliance to a power source

Connect the power cable to one of the inlet receptacles on the back of the appliance, and

connect the other end of the power cable to a power outlet.

Connecting the appliance to the network

Connect the interfaces on the appliance to the network ports on the appropriate

switches by using Ethernet/fiber optic cables.

Note: Citrix SD-WAN 11.1 supports day-0 provisioning and day-n management of the

appliance through both management and data ports.

Warning: Connecting multiple network ports to the same switch or VLAN can result in a

network loop.

Setting up the appliance

1. If you are configuring the appliance using Zero Touch Deployment (ZTD), see Zero

Touch.

2. If you are configuring a hardware SD-WAN appliance, physically connect the

appliance to a PC. For more information, see

Setting up the Appliance Hardware.

已註解

[PK[4]:

已註解

[PK[5R4]:

I think the content in the topic, need to be

made generic. Applicable to all LTE appliances. Please

confirm.

已註解

[PK[6]:

The ZTD procedure will be updated as per

the new 11.1.0 in-band provisioning feature. The link will be

updated when the release happens and the document is

published.