Quick Start Guide

Citrix SD-WAN 110-LTE-WiFi-SE Quick Start Guide

To set up your Citrix SD-WAN appliance hardware, do the following:

1. Set up the chassis.

For desktop installation, place the chassis on a flat surface. Ensure that there is a

minimum of two inches of clearance at the sides and back of the appliance for

proper ventilation.

2. Connect the Power.

a. Ensure that the power switch is set to off.

b. Plug the power cord into the appliance and an AC outlet.

c. Press the power button located on the front of the appliance.

3. Connect the appliance Management Port to a personal computer.

You need to connect the appliance to a PC in preparation for completing the next

procedure, setting the Management IP address for the appliance.

Note

Before you connect the appliance, ensure the Ethernet port is enabled on

the PC. Use an Ethernet cable to connect the SD-WAN appliance

Management Port to the default Ethernet port on a personal computer.

To configure the management IP address for a hardware SD-WAN appliance, do the

following:

Note

You must repeat the following process for each hardware appliance you want to add to

your network.

1. If you are configuring a hardware SD-WAN appliance, physically connect the

appliance to a PC.

•

If you have not already done so, connect one end of an Ethernet cable to the

Management Port on the appliance, and the other end to the default

Ethernet port on the PC.

Note

Ensure that the Ethernet port is enabled on the PC you are using to connect

to the appliance.

2. Record the current Ethernet port settings for the PC you are going to use to set the

appliance management IP address.