Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Operating Modes
- 3.5. Power Saving
- 3.6. Power Supply
- 3.7. Power-on/off Scenarios
- 3.8. Reset the Module
- 3.9. (U)SIM Interfaces
- 3.10. USB Interface
- 3.11. UART Interfaces
- 3.12. PCM and I2C Interfaces
- 3.13. SPI Interface
- 3.14. Network Status Indication
- 3.15. STATUS
- 3.16. ADC Interface
- 3.17. Behaviors of RI
- 3.18. USB_BOOT Interface
- 4 GNSS Receiver
- 5 Antenna Interfaces
- 6 Electrical, Reliability and Radio Characteristics
- 7 Mechanical Dimensions
- 8 Storage, Manufacturing and Packaging
- 9 Appendix A References
- 10 Appendix B GPRS Coding Schemes
- 11 Appendix C GPRS Multi-slot Classes
- 12 Appendix D EDGE Modulation and Coding Schemes
LTE Standard Module Series
EG91 Hardware Design
EG91_Hardware_Design 95 / 93
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will
be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that
20 cm may be maintained between the antenna and users. The final end product must be labeled in a
visible area with the following: “Contains FCC ID: XMR201907EG91VX”. The grantee's FCC ID can be
used only when all FCC compliance requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module. The end
user manual shall include all required regulatory information/warning as show in this manual.