Getting Started Guide In-cab telematics tracker Made by:flex Model: FT500-LM0Q-GL/ 0 | Rev. 0.
In-cab telematics tracker Safety Warnings Read this complete guide before installing the device. This device contains a Lithium Ion battery. If these guidelines are not followed, the battery may experience a shortened life span or may present a risk of damage to the device, fire and/or bodily injury. —Do not penetrate the battery or device with a nail etc., nor make a hole in the battery.
LED The LED indicate device activity at start-up and its live functional status. Blue Green Red Off GPS Off Modem Off Device off or sleeping On GPS has location fix Connected to cellular network System is awake Rapid Flash Medium Flash Receiving GPS location Transferring cellular data Telematics transferring data (if Searching for satellites Searching for cellular network Device unlocked (3 sets of 4) Powering on the Device 1.
Troubleshooting Symptom Action LED slow flashes a repeated pattern of LED flashes after supplying power to the device The device is in error state; check the error codes above for corresponding actions LED doesn’t not illuminate after supplying power to Replace the device the device.
Review this installation manual to become familiar with all installation procedures and electrical wiring requirements prior to starting the installation. This installation guide has been prepared to provide you with details necessary to complete the device installation. Use of proper tools and testing equipment is required. Never use a grounding style test light. Use only aDigital Multi Meter (DMM) to test wires in the vehicle.
duringcranking and while motor is running. Connect the device’s white/yellow wire here. Connector cable color table: Pin no. Cable definition Color 1 12V_VDC_OUT（ (12V or 24V) up to 1.5A @12V） Purple 2 Switched Output 1 (relay Control) Black/Brown 3 Switch input 2_CON (Programmable Bias) White/Gray 4 RS232_Tx1 Orange 5 CAN_H1_CON (CANH 2.
Depending on GPS and cellular signal, a typical sequence may proceed as follows: 1) Power LED-Power on (~30s). 2) Data LEDmedium flashing- Retrieving network time. 3) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location. 4) GPSLED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy. 5) GPS LED off. 6) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location.
FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. It maintains at least a 20 cm separation between the EUT and the user’s body and must not transmit simultaneously with any other antenna or transmitter. ISED Warning statements This device complies with Canada's licence-exempt RSSs.
CAT4: FDD B2/B4/B5/B12/B13 _________________________________________ 8 | Rev. 0.
