Declaration of Conformity

ManualsBrandsQuectel ManualsElectronicsLTE Module

Supplier's Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Model Name

As stated on agency label

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Responsible Party – U.S. Contact Information

Ribbon Communications Inc.

5225 Hellyer Ave., Suite 100

San Jose, CA 95138, USA

Tel: +1-408-351-7200

ribboncommunications.com

___________________________________________

(SIGNATURE)

Summary of content (4 pages)

PAGE 1
Supplier's Declaration of Conformity 47 CFR § 2.1077 Compliance Information Model Name As stated on agency label FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party – U.S. Contact Information Ribbon Communications Inc. 5225 Hellyer Ave.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS - When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: — Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. — Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
PAGE 3
be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer. B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised. C) Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.
PAGE 4
GARDEZ CES INSTRUCTIONS ATTENTION: Pour une protection continue contre le risque d’incendie, ne changez les piles qu’avec un type et des spécifications identiques du fusible ATTENTION: Risque d’explosion si la pile est changée avec un type incorrect. Veuillez recycler les piles usages selon les Instructions. ATTENTION: Pour réduire le risque d’incendie, n’utilisez qu’un cordon électrique pour les télécommunications certifié UL ou CSA No. 26 AWG ou plus grand (par exemple, 24 AWG).