Positioning Universal Inc TM95M User Manual 1
Positioning Universal Inc Contents 1 Introduction ....................................................................................................................3 1.1ID and Tooling Design.......................................................................................................3 2 Hardware.........................................................................................................................3 2.1 Physical and Electrical Specifications .......................................
Positioning Universal Inc 1.1 ID and Tooling Design Dimensions: 83.5mm*47.5mm*18mm 2.1Physical and Electrical Specifications Input Voltage: 7-36VDC Power consumption: - Active mode: 100mA ＠12VDC - Sleep mode: <5mA ＠12VDC Operating temperature: -30℃ to 80℃ Storage temperature: -30℃to 80℃ 2.2 Input/Output Download and debug port: 1 SWD Interface: 1 Function LEDs: 2 GPS Status Green Cellular Status Orange Buzzer:1 Input:1 Output:1 2.
Possitionin ng Univ versal Inc 2.6 System ne etwork structure GPS S alarm is currently the t most advanced security Setttings. GPS S alarm mo ore exp pensive tha an ordinary y burglar alarm, and need to pa ay the additional serv vice fee,, so the po opularity is not high.
Positioning Universal Inc 3.1 Introduction. This chapter is user manual for TM95M. One DC 12V cable. Connect the DC 12V cable to the connector of J101 on the device, the other side connect to DC 12V, you can use the DC 12v cable to supply power.
Positioning Universal Inc FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Positioning Universal Inc FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
