Users Manual

Smart Module Series
SC200R Series Hardware Design
SC200R_Series_Hardware_Design 11 / 125
including: This product must be in-stalled and operated with a minimum distance of 20 cm between the
radiator and user body. This device have got a FCC ID: XMR20SC200RWF.The final end product must be
labeled in a visible area with the following: “Contains Transmitter Mod-ule FCC ID: XMR20SC200RWF”
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be
installed such that 20cm is main-tained between the antenna and users, and 2) The transmitter module
may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met,
further transmitter test will not be required. However, the OEM integrator is still responsible for testing
their end-product for any additional compliance require-ments required with this module installed.
Declaration of Conformity European notice.
Canada Regulations:
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présentappareilestconforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitationestautorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d’encompromettre le fonctionnement. Caution：
A label with the following statements must be attached to the host end product: This device contains IC:
10224A-20SC200RWF.
The manual provides guidance to the host manufacturer will be included in the documentation that will be
provided to the OEM. The module is limited to installation in mobile or fixed applications.
The separate approval is required for all other operating configurations, including portable configurations
and different antenna configurations. The OEM integrators are responsible for ensuring that the end-user
has no manual or instructions to remove or install module.
The module is limited to OEM installation ONLY.
Une étiquette avec les instructions suivantes doit être attachée au produit final hôte:
Cet appareil contient IC: 10224A-20SC200RWF.
Le manuel fournit des conseils au fabricant hôte sera inclus dans la documentation qui sera fournie à
l'OEM. Le module est limité à l'installation dans des applications mobiles ou fixes.
L'approbation distincte est requise pour toutes les autres configurations de fonctionnement, y compris les
configurations portables et différentes configurations d'antenne.
Les intégrateurs OEM sont responsables de s'assurer que l'utilisateur n'a pas de manuel ou d'instructions
pour retirer ou installer le module.
Le module est limité à l'installation OEM SEULEMENT.