Instruction manual

1
2 3
4 5
6
19
Stitch selector
A
F
E
G
C
B
D
K
J
1
3
4
2
Selected Stich
Buttonhole foot
Upper thread
tension control
1 - 5
4
3
2
Stitch lenght
control
0.5 - 0.8
Set the stitch selector at:
Sew 5 stitches of bartack and
raise the needle from the fabric.
2-41 3
Buttonhole Stitching
Make a test buttonhole and a sample
duplicating the fabric, interfacing and seams
of the actual garment. Place the button on the
fabric sample and mark the top and bottom to
determine the buttonhole length.
Set the stitch selector at
Slide both threads to the left.
Lower the needle into the garment where the
buttonhole is to start, and lower the foot.
Sew down the left side stopping at the bottom
mark. Raise the needle.
Remove the fabric from the machine and cut
the sewing threads. Insert a pin as stopper inside
the bartack. Then cut the opening with a seam ripper.
Set the stitch selector at:
Sew up the right side of the
buttonhole. Stop the machine
when you are directly opposite the rst stitch
on the left hand side and raise the needle.
1
3
2
4
0
1
Set the stitch selector at:
Sew a few bartacks and raise the needle from
the fabric. Set the stitch length control to “0“
and the stitch selector at straight stitch sewing.
Sew a few locking stitches.
2
4
ENGLISH