Instruction manual

22
Oil with one
drop of oil.
CARE OF YOUR MACHINE
Disconnect your machine from the power source
When caring for your machine, or cleaning it, unthread it and disconnect the presser, even when
you change the needle.
Open the hook race ring holders
and remove the hook race ring.
To dismantle hook race:
Raise the needle to its highest
position and open the hook
cover. Open the hinged latch of
bobbin case and take it out of
the machine.
Remove the hook.
Clean the hook race with a
brush and a soft dry cloth.
To assemble hook race:
Hold the hook by the center pin and t it
carefully back into the hook race, forming a
perfect circle with the shuttle driver. Attach the
hook race ring making sure bottom pin ts into
the notch. Lock the hook race by turning the
holders back into position. Insert the bobbin
case. Thread the machine and bobbin, connect
the machine to the power point and sew after
switching on the machine.
Fitted in the machine.
Cleaning the Feed Dogs
Remove the needle and the presser foot.
Unscrew the needle plate set screws and
remove the needle plate.
With a brush, clean out dust and lint clogging
on the feed dog teeth.
Replace the needle plate. Tighten screws.
NOTE: It is easier if you lay the machine on its back to replace the race.
ENGLISH