miniCool ® TYP: A 803 E Operation instructions 207.5079.
Fig. 1.
INTRODUCTION We are pleased that you have chosen this refrigerator and trust that it will be to your complete satisfaction. We should also like to offer some useful tips. ) freezer compartment (-18°C) for This absorption refrigerator has a ( freezing ice and storing deep-frozen food. (These values are maintained at ambient temperatures of between +16°C and +32°C). The normal refrigerator compartment is cooled by a separate evaporator.
PUTTING INTO SERVICE The 230V electricity supply must be provided by a socket earthed in accordance with current regulations. Before putting the refrigerator into service, please ensure that the mains connection voltage corresponds to the voltage indicated on the type plate. TEMPERATURE CONTROL An absorption refrigerator operates without making any noise whatsoever. The deep freezer compartment should become cold approximately one hour after being switched on.
- Set the thermostat at 0', disconnect at the mains, remove food and ice dish and leave the doors open. Do not expose the refrigerator to external heat and do not attempt to scratch away the frost with sharp objects. - The drained water runs in a groove and from there continues along a pipe through the refrigerator's rear panel and into a collection container on the cooling unit, where the water evaporates by itself.
Should the refrigerator not be cooling sufficiently, it may be because: the cooling unit is insufficiently ventilated, owing to the air inlet or ventilation aperture (mesh in the table top) being completely or partly covered the evaporator is covered with ice the thermostat setting is incorrect too much (warm) food has been stored in the refrigerator over a short period of time the door seal is not in its correct position, or the door is not properly closed.
INSTALLATION DIRECTIONS Installation, particularly electrical work, must be carried out by a qualified expert. For instance, should the refrigerator be installed in a cupboard unit, adequate ventilation and aeration and the correct distance from the wall must be ensured as indicated in diagram 2 (A or B). During installation, please ensure the mains plug is accessible at all times.
DOOR DECORATION PLATE A door decoration plate can be changed or fitted quite simply. The plate's dimensions must be as follows: height ..............................522 mm width ................................507 mm thickness .................max. 3.0 mm detach and remove the plastic strip from the frame at one end pull the door plate slightly downwards pull the plate from the middle to the outside until it can be detached on the side fit in the new plate and push it upwards attach plastic strip.
TECHNICAL DATA Outer dimensions of the refrigerator height .....................................................575 mm width .......................................................525 mm depth ......................................................530 mm Capacity gross ......................................................70 lit useable capacity ....................................65 lit freezer compartment capacity ..................................................6.0 lit Weight (excluding packaging) ......
A Fig. 2 10 A - min.
Printed by Xerox Hungary Ltd. Rev.: 2003. 12. 23.
