Technical data

126 • BACnet/IP Controller 750-830
LED Signaling
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
3.1.9.2 Node Status – "I/O" LED Blink Code
Tab. 3-23: Node status
LED Color Meaning
I/O Red /green /
orange
The "I/O" LED indicates the operational status of the node and
signals any errors.
After applying the supply voltage, the controller boots up. The red ‘I/O‘ LED
blinks.
After an error-free run-up, the "I/O" LED stays lit as green.
In the event of a failure, the ‘I/O’ LED will blink continuously.
Detailed error messages are indicated by means of blinking codes. An error is
indicated cyclically by up to 3 blinking sequences.
• The error display starts with the first blinking sequence (approx. 10 Hz).
• After a short break, the second blinking sequence starts (approx. 1 Hz).
The number of light pulses indicates the error code.
• After another break, the third blinking sequence starts (approx. 1 Hz). The
number of light pulses indicates the error argument.
‘I/O’ LED is blinking
Test o.k.?
No
Yes
‘I/O’ LED is shining
ready for operation
2nd break
1st break
‘I/O’ LED
1st flash sequence
(Introduction of the
error indication)
‘I/O’ LED
2nd flash sequence
Error code
(Number of flash cycles)
‘I/O’ LED
3rd flash sequence
Error argument
(Number of flash cycles)
Coupler/Controller starts up
Switching on
the power supply
Fig. 3-23: LED signaling of the node status g012111e