User manual

HPi110 & HPi210
Quick Rig (QR) Systems
User Manual
HPi110 & HPi210 Quick Rig (QR) Systems
10
Installation of the Spine on the HPi110
NOTE: The 2 x M10 bolts supplied with both the i-Spine and t-Spine should replace the
previously installed screws in the speaker. The M10 bolts are designed with a longer thread
which provides increased strength and security to the system.
Primary Applications Include:
• Wall Mount applications where tilt is
not needed
• Vertically Arraying 2 Speakers
The touring Spine (t-Spine) is
recommended for a precise and easy
hanging setup of the speaker when
used when flying a single speaker.
The holes, on each side, allow for a 5o
stepped tilt of the cabinet [from -15o
to +45o]
Only one rated shackle is necessary
to use the Spine in most applications.
(A quick-pin is also included with the
t-Spine)
The t-Spine can also be used as part of
a more complex rigging system.
Ordering reference:
ACHPiATS
Remove the 2 top
screws that are
installed in the speaker
then insert the lip of
the Spine to grab the
casing handle.
Swing it flat on the
top of the speaker.
Bolt in and secure
(using Loctite or similar
fastener securing
compound) the Spine
onto the speaker with
the 2 x M10 bolts
included.
1
2 3