User manual

HPi110 & HPi210
Quick Rig (QR) Systems
User Manual
HPi110 & HPi210 Quick Rig (QR) Systems
11
Installing an HPi110 becomes easy with the
QR wall-mounting system.
Once the spine has been installed (as
described above) install the wall-mount as
follows:
1. Bolt the wall mount assembly (without
the speaker attached) onto the wall.
2. Lift the speaker (now installed with
Spine) and hook it onto the wall-mount.
The wall-mount is designed to safely
support the weight of the box from this
point.
3. Set the angle by sliding the quick-pin
into the right hole (see next section for
angles).
HPi110 with
i-Spine
Fixed hook
assembly
HPi110 with Kit QR2 Standard
HPi110 with Kit QR2 Long Side Plates
7.5 degrees 15 degrees 30 degrees0 degrees
Setting the Angle of the Cabinet
Once the speaker has been mounted correctly, the angle at which the speaker will be fixed can be
adjusted by fitting the Q-Pin into the correct hole. Four angles are available:
The standard kit offers the possibility to hang
a speaker at 0˚ and 7.5˚.
If extra tilt (15˚ or 30˚) is needed, optional
extension plates can be purchased separately
and inserted in the wall-mount assembly.